AOSEPT PLUS with HydraGlyde Economy Pack 360ml and 90ml

Active Ingredients

Contains Hydrogen Peroxide 3%, Phosphonic Acid, Sodium Chloride, Phosphate, Poloxamer, HydraGlyde Moisture Matrix (EOBO-21— Polyoxyethylene-Polyoxybutylene).

Directions

NEVER put AOSEPT PLUS with HydraGlyde solution into your eye OR onto a contact lens immediately before inserting the lens into your eye. Otherwise, burning and stinging will result.

1. Wash your hands and dry them with a clean, lint free towel.
2. Open the lens holder marked “L”, remove your left lens and place it on the dome. Close lens holder taking care to avoid trapping your lens.
3. Repeat procedure with your right lens placing it on the dome of the other lens holder marked “R”.
4. Open the flip top cap on the AOSEPTTM PLUS with HydraGlyde bottle and bend it back and out of the way
5. Thoroughly rinse the lenses in the lens holders with AOSEPT PLUS with HydraGlyde for 5 seconds
6. Fill the cup with AOSEPTTM PLUS with HydraGlyde solution to the fill-line. DO NOT UNDERFILL OR OVERFILL
7. Place lens holder in the lens cup and screw closed. Do not over tighten the AOCup lens case (only tighten finger tight). DO NOT SHAKE THE LENS CASE.
8. Store lens case upright
   – If bubbles leak from the hole in the top of the lens case’s cap, non-neutralised AOSEPTTM PLUS with HydraGlyde solution may be present. Empty the solution from the lens case and wash off any spillage from the surface on which the AOCup lens case was standing. Thoroughly rinse the lens cup and lens holder with sterile saline. If spillage occurs, clean up immediately with a paper towel. Wash your hands thoroughly before handling your lenses or touching your eyes. REPEAT THE DISINFECTION PROCEDURE ABOVE.
9. Allow lenses to soak for a minimum of 6 hours or overnight to neutralise solution.
10. After washing, rinsing and drying your hands, remove your lenses from lens holder.
11. If desired or recommended by your eye care professional: Rinse lenses before insertion with STERILE SALINE after neutralisation. Do not use AOSEPT PLUS with HydraGlyde to rinse lenses before insertion.
12. Your lenses are now ready to wear.
13. Discard used solution, rinse the lens cup and lens holder with sterile saline – DO NOT USE TAP WATER OR OTHER NON-STERILE LIQUIDS.
14. Allow them to air-dry by inverting the lens holder outside the cup. Do not place the lens case on its side.
15. If you do not intend to wear your lenses immediately after disinfection/neutralisation, you may store them in the neutralised AOSEPTTM PLUS with HydraGlyde solution, in the unopened AOCup lens case for up to 14 days. After this time, your lenses must be cleaned and disinfected with AOSEPT PLUS with HydraGlyde prior to wear.

Caution

Red flip top cap color means: Never put non-neutralised AOSEPT PLUS with HydraGlyde solution directly into the eye. NEVER put AOSEPT PLUS with HydraGlyde solution onto a contact lens immediately before inserting the lens into your eye. Lenses must be soaked in the provided lens case for at least 6hours (neutralisation process) prior to insertion. NON-NEUTRALISED AOSEPT PLUS WITH HYDRAGLYDE SOLUTION IS A HIGHLY EFFECTIVE DISINFECTANT WHICH WILL CAUSE A BURNING AND STINGING SENSATION if allowed to make contact with the eye. If you accidentally insert a non-neutralised lens, remove it immediately and rinse the open eye with plenty of sterile water or sterile saline. Repeat the disinfection procedure mentioned before reinserting it. If burning or stinging continues, seek immediate assistance from an eye care professional before resuming contact lens wear. NEVER ATTEMPT TO CLEAN OR RINSE YOUR CONTACT LENSES IN YOUR HANDS WITH AOSEPT PLUS WITH HYDRAGLYDE SOLUTION. A MILD, TEMPORARY SKIN DISCOLORATION (BLEACHING) MAY RESULT UPON CONTACT WITH NON-NEUTRALISED SOLUTION. Always wash, rinse, and dry your hands after exposure. NEVER ATTEMPT TO CLEAN YOUR CONTACT LENSES WITH A SEPARATE CLEANER AS ANY RESIDUAL CLEANER WILL RESULT IN FOAMING CAUSING THE SOLUTION TO OVERFLOW FROM THE LENS CASE AND INCOMPLETE NEUTRALISATION OF AOSEPT PLUS WITH HYDRAGLYDE SOLUTION. To maintain product efficacy: ONLY USE THE ENCLOSED AOCUP LENS CASE. DO NOT USE ANY OTHER LENS CASE. Do not use another solution with the provided lens case. Always use fresh AOSEPT PLUS with HydraGlyde solution – never re-use solution in your lens case. NEVER dilute or mix AOSEPT PLUS with HydraGlyde with any solution as this will destroy its performance. NEVER transfer AOSEPT PLUS with HydraGlyde solution to another container. NEVER ALLOW CONTACT LENSES TO COME INTO CONTACT WITH NON-STERILE LIQUIDS (INCLUDING TAP WATER AND SALIVA) AS MICROBIAL CONTAMINATION CAN OCCUR, WHICH MAY LEAD TO PERMANENT EYE DAMAGE. KEEP OUT OF REACH OF CHILDREN. If non-neutralised AOSEPT PLUS with HydraGlyde solution is swallowed, immediately drink large amounts of water and consult your doctor. Consult your doctor or eye care professional before using any medication with contact lenses. Follow your eye care professional’s directions and all labelling instructions for proper use and care of your lenses and lens care products, including the lens case. Do not use if tamper evident bottle seal is broken or missing. Close bottle after use. Keep out of reach of children. Not to be taken.